User's Manual

14221-1200-4010, Rev. B
34
The RF cable (W90-0223-001) which interconnects the MRU VHF Low Band connector to
the RF connector on the LBPA Radio Connector is approximately 12-inches long. If the
units are mounted separately, they must be located so the respective connectors of the cable
can mate to the connectors on the rear of the units. Typically, both brackets should be
mounted within approximately twelve (12) inches of each. The brackets/radios may be
oriented parallel or perpendicular to each other.
TOP VIEW WITH SCREW HOLE DIMENSIONS (In Inches)
Figure 7-1: Base Bracket 1000003678 (Part of XM-ZN2G Installation Kit)
NOTE
Side Mounting
Tabs
(4 places)
Bracket-To-Vehicle Mounting
Surface Screw Holes
(10 places)
Bracket-To-Radio Screw Holes
(6 places, 3 each side)
Four (4) Upper-Most Holes
(2 each side) Used to Attach
Extension Brackets