User's Manual

14221-1200-4010, Rev. B
22
5. UNPACKING AND CHECKING THE EQUIPMENT
Upon receipt of the Harris equipment, carefully unpack the equipment and verify that the order is
complete. Inspect the equipment for any shipping damage. If there is any damage to the equipment,
contact the carrier immediately and have their representative verify the damage. If you fail to report the
shipping damage immediately, you may forfeit any claim against the carrier.
When unpacking the equipment, check the contents against the packing list. Contact your Harris
representative and the carrier if any discrepancies are noted.
After verifying all equipment is accounted for, proceed with the installation.
After removal from the carton, examine the mobile radios, control head, and other
components for broken, damaged, loose, or missing parts. If any are noted, contact the
Customer Care center (see page 21) immediately to discuss and arrange the return of the
equipment to Harris for replacement. Any unauthorized attempts to repair or modify this
equipment will void the warranty and could create a safety hazard.
5.1 MATERIALS
A typical set of installation materials for a Unity XG-100M mobile radio with XG-100LPA VHF Low
Band Amplifier includes:
 Unity XG-100M Mobile Radio -refer to Table 5-1.
 Unity XG-100LPA 100W Low Band Power Amplifier -refer to Table 5-1.
 CH-100 Control Head [12099-1200-01; catalog number XMCP9R].
or
 CH-721 System Control Head [part number CU23218-0004; catalog number MAMW-NCP9F].
 Standard Microphone [part number MC-101616-041; part of catalog number MAMW-NMC7Z].
 Installation Kits:
 Unity XG-100LPA – contents listed in Table 5-2.
 XG-100M with Remote CH-100 Control head - contents listed in Table 5-3.
 XG-100M with Remote CH-721 System Control head - contents listed in Table 5-4.
 Two (2) or Three (3) Antennas - refer to Table 5-5 for VHF Low Band antennas and Table 5-6 for
other XG-100M antenna options.