User's Manual

Document Number/Ref.-No. Issue
00-6383A01 1.0
(113491 2)
Page 22 of 26
Copyright  2000 by Harris Corporation, RF Communications Division
All rights reserved. No part of this publication may be reproduced or transmitted in
any form or by any means, electronic or mechanical, including photocopy, recording, or any information storage and retrieval system, without permission in
writing by
Harris Corporation, RF Communications Division,
Rochester, New York, USA
exit
This command causes the application to terminate.
--------------------
log [start/stop/reset/filename] [filename.ext]
Control the logging of data.
With no arguments, terminates data logging.
[start] Begin logging all transmitted and received data to a data log file named "LOGFILE.TXT". Data is appended
to the existing log file if one exists, else a new file is created.
[stop] Terminate data logging
[reset] Causes the log file to be deleted and, if logging is currently enabled a new log file is created
[filename.ext] logfile.txt Sets the logging file name to "logfile.txt"
--------------------
scrn 0/1
Set the number of rows displayed on the screen. This command clears the screen and repositions the cursor to the
top line of the screen.
0 Set number of lines on screen to 25
1 Set number of lines on screen to 50
--------------------
tick [0/1]
Causes a single character, a '-', to be displayed once per second.
With no arguments, displays whether the tick option is enabled or
disabled.
0 disables this option
1 enables this option
--------------------
show [text]
Causes the text following the command "show" to be displayed on the screen. This text is displayed in Light Grey.
--------------------