User's Manual

Document Number/Ref.-No. Issue
00-6383A01 1.0
(113491 2)
Page 20 of 26
Copyright  2000 by Harris Corporation, RF Communications Division
All rights reserved. No part of this publication may be reproduced or transmitted in
any form or by any means, electronic or mechanical, including photocopy, recording, or any information storage and retrieval system, without permission in
writing by
Harris Corporation, RF Communications Division,
Rochester, New York, USA
[v] Display command response in verbose format
--------------------
tce t/r [v]
Sends a TCXO Adjustment Enable message to the receiver or the transmitter.
t Send a TCXO Adjustment Enable Command Message to the transmitter
r Send a TCXO Adjustment Enable Command Message to the receiver
[v] Display command response in verbose format
--------------------
tcd t/r 0/1 [v]
Sends a TCXO Adjustment Direction message to the receiver or the transmitter.
t Send a TXCO Adjustment Direction Command Message to the transmitter
r Send a TXCO Adjustment Direction Command Message to the receiver
0 Decrease the frequency
1 Increase the frequency
[v] Display command response in verbose format
--------------------
ver
Displays the version of the LHS, receiver software (DSP and MICRO), receiver hardware, transmitter software (DSP
and MICRO), and transmitter hardware (PA and PS)
An example printout:
LHS 23
TX DSP 10
TX MICRO 11
TX PA 11
TX PS 20
RX DSP 20
RX MICRO 11
--------------------