User's Manual

Document Number/Ref.-No. Issue
00-6383A01 1.0
(113491 2)
Page 19 of 26
Copyright  2000 by Harris Corporation, RF Communications Division
All rights reserved. No part of this publication may be reproduced or transmitted in
any form or by any means, electronic or mechanical, including photocopy, recording, or any information storage and retrieval system, without permission in
writing by
Harris Corporation, RF Communications Division,
Rochester, New York, USA
mra [0] [s/r]
This command allows adjustment of the rate of data messages sent to from the LAAS Host Simulator to the
transmitter.
With no argument, displays the current skip value and the current message rate value.
[0] Sets the message rate to be synchronized to the Transmitter Time Mark
[s] Displays a menu alowing the user to select the SKIP value to be set (Range 0 - 255)
[r] Displays a menu alowing the user to select the Message Rate to be set ( Range -25 to 25 (mS) )
--------------------
rpe [0/1]
Remote Power Enable, controls the turning on and turning off of the transmitter.
No argument displays the current state of the remote power enable line
[0] Turns the transmitter off
[1] Turns the transmitter on
--------------------
sdc [0/1] [v]
Displays the current power source and allows changing the current power source.
No argument displays the response to the current power source request in hex format
[0] Sends a command message to switch the transmitter to the AC power source
[1] Sends a command message to switch the receiver to the DC power source
[v] Display command response in verbose format
--------------------
cwt 0/1 [v]
Enables/disables the transmission of a constant waveform.
0 Stops the transmission of the CW signal
1 Starts the transmission of the CW signal. The current frequency and power settings are to be used