User Manual Part 3

4-12
RF-7800B
CONFIGURATION
R
4.3.5.1 ACA settings for TE with Static IP address:
A custom range of static IP addresses can be used for setting up an automatic PDP context with any of the QoS's
offered by the network. To turn on a particular range of addresses:
a. Select On and enter the low and high range of IP addresses to use (e.g. 192.168.128.210 to
192.168.128.219).
b. Select the desired QoS for that range of IP addresses (32 k) for streaming. The APN listed is the default
APN read from the USIM card (bgan.inmarsat.com). If the USIM is provisioned for more than one
APN, then type a secondary APN in this field.
c. If a user name and password is required by the Service Provider, enter it in the next two fields.
To setup additional ranges of addresses, follow the same instructions as above. IP address ranges cannot overlap. If
there is an overlap, an error will pop-up for the overlap region. Check all of the ranges for overlaps and try again.
When finished, select Apply. The Operation Successful message should display.
4.3.5.2 ACA settings for TE using DHCP assigned IP address
This option allows the BGAN terminal to be set up for dynamic background ACA. This means that any device
connected to the BGAN terminal, will automatically receive a background PDP context. To activate this feature:
a. Select the On radio button under ACA settings for TEs using DHCP assigned IP address.
b. Click on Apply.
To see if the context has been setup properly, click on PDP Contexts page. This page will show all contexts that have
been setup (active or inactive). See Figure 4-5.