User Manual

39
Figure 7-4 Double Fall Chain Connections
7.3 Pendant
7.3.1 The following procedure covers the installation of the Pendant Hose (Parts List Figure Number 360)
and the Pendant Valve. Refer to Figure 7-5.
1) Place boot on the ends of the Pendant Hoses to be attached to the Manifold Block on the hoist.
2) Attach pendant hose to hoist body using the one-piece fittings and screw type clamps (hose bands).
3) Attach pendant hoses to the pendant valve using the 2 piece fittings and crimp type hose clamps (hose
bands). Refer to Figure 7-5 for the correct placement of the Hoses.
4) Attach the Strain Relief wire S-Hook on the Pendant Valve and Manifold Block using the S-Hook.
5) Slide the Boot in to place over the Hose Fittings at the Manifold Block on the hoist.
6)

Operate hoist and make sure the direction of hook travel agrees with the control
levers on the Pendant Valve.