User guide
61
10) Carry out again all the sequences described in Section 6.6 “Reeving and Adjustments”. Lubricate the Wire
Rope, the Rope Guide and Drum (see Section 6.2).
11) Retighten clamping plates. Torque the Screws to the value shown in Table 6-1 for your hoist (see Figure 6-8).
12) Run rope in with a partial load.
Table 6-1 Rope Clamp Torque Values
Hoist Capacity Code
RHN02, RHN03
RHN05
RHN08, RHN10
RHN15, RHN20
Screw Dia (mm)
M10
M10
M12
M16
Screw Torque
30 ft-lbs.
(40Nm)
39 ft-lbs.
(50Nm)
64 ft-lbs.
(87Nm)
155 ft-lbs
(210Nm)
Figure 6-10
Figure 6-11
Figure 6-12
Figure 6-13
Figure 6-14
Figure 6-15