Manual

43
12) Remove the Wire Clamping Spring (T) using the Wire Rope Guide Clamping Tool (S) and pliers to
remove the Clip (U) (see Figure 6-16).
13) Unscrew the Nuts (X) remove the Screws (V) and the Springs (W) from the Rope Guide Ring Halves
(P and Q), then remove the Ring Halve (Q) (see Figure 6-17).
14) Loosen the Screws (A1) of the Wire Rope Clamps (B1) and take out the Wire Rope and Ring Half (P)
(see Figure 6-18). For 4/1 Ultra-Low headroom versions it is necessary to rotate the Ring Half (P) over
the top of the drum to remove it from the hoist (see Figure 6-19).
Figure 6-16
Figure 6-17
Figure 6-18
Figure 6-19