Owner manual

Table 5-3 Hoist Inspection Methods and Criteria

Use this table in conjunction with Table 5-3 of the EROM. The entries in this table replace in their entirety

the corresponding entries in Table 5-3 of the EROM.

Item Method Criteria Action

Motor Brake Measure, Visual Motor brake gap should be adjusted to the

distance shown in Table 6-3 before measuring

the brake wear. Brake lining dimension “A”

should not be less than discard value listed in

Table 5-6. Refer to Section 6.3 of the EROM for

gaining access to motor brake and for adjustment

and inspection procedures. Braking surfaces

should be clean, free of grease/oil and should not

be glazed.

Adjust, Repair or

Replace as

required.

Table 5-4 Top Hook & Bottom Hook Dimensions

“k” Measured When New:

Top: _________________________

Bottom: ______________________

"u" Dimension

inch (mm)

"t" Dimension

inch (mm)

Capacity Code

Nominal "k"

Dimension*

inch (mm)

Standard Discard Standard Discard

080S, 100L, 100S

4.72(120) 2.87(73) 2.60(66) 1.89(48) 1.69(43)

150S

5.04(128) 3.43(87) 3.07(78) 2.36(60) 2.13(54)

200S

5.57(141.5) 3.92(99.5) 3.54(90) 2.76(70) 2.48(63)

* These values are nominal since the dimension is not controlled to a tolerance. The "k"

dimension should be measured when the hook is new - this becomes a reference measurement.

Subsequent measurements are compared to this reference to make determinations about hook

deformation/stretch. See Section 5.7 of EROM, “Hooks - Stretch”.