Installation & Assembly

If you nd you need to remove a drawer, push and hold the

track tabs outward and pull the drawer out the rest of the way.

BOTTOM OF THE DRAWER

TRACK

TAB

TRACK

TAB

Congratulations on the purchase of your two drawer nightstand. This nightstand has been crafted to the highest

standards of quality and safety and will give you many years of enjoyment and practical use.

This nightstand is a natural wood product and has been nished with a distressed patina. There will be variations in

color and grain, and minor wood grain checking may occur. This is normal and does not compromise the integrity of

your dresser. Variation in the character of this piece is integral to its beauty and distinguishes it from lower quality

composite materials.

Assembly is quite simple and requires only a at head or Phillips head screwdriver. The use of a power drill with the

clutch set to low and a Phillips head attachment is helpful but not necessary. Assembly will be most easily accomplished

if you take the time to carefully sort the hardware and familiarize yourself with the function of each piece.

Thank you and Enjoy

Two Drawer Nightstand

Drawer handles are pre-installed

into each drawer for shipping.

(As shown in Diagram I)

To install drawer handles, rst

unscrew the handle from the inside

of the drawer. Place the handle on the

outside of drawer and insert the screw

through the pre-drilled hole located on

the inside of the drawer. Tighten using

at head or Phillips head screwdriver.

(As shown in Diagram II).

*NOTE: Do not turn the handle to tighten or loosen

the screw. Doing so will cause the handle

to scratch the front of the drawer.

1/1

HAVE QUESTIONS OR CONCERNS? CALL US FIRST: 1-800-589-7990