Assembly Instructions

WARNING: ADULT ASSEMBLY REQUIRED
WARNING: Assembly kit contains parts with sharp edges.
WARNING: Assembly kit contains parts with sharp points.
WARNING: Package contains plastic bags that present suffocation risks for children.
WARNING: Assembly kit contains small parts that present choking hazards for children.
Page 1 of 1
Contents:
2- Arm/Leg Sets (A1 & A2) 1- Seat Assembly (B)
1- Back Assembly (C) 2- Rocker (D)
14- Cap Nuts 14- Washers
10- 1 3/4" Bolts 4- 2 1/2" Bolts
2- 1 5/8" Wood Screws
2. Slide the back assembly into the slots behind the seat so that it looks like the drawing. Hold the Arm/
Leg Set (A1/A2, identify the left and right side using the image above) and the Seat Assembly (B) into
position so that the holes line up and install two 1 3/4" Bolts. Start a Washer and a Cap Nut on each bolt
and tighten hand tight only. Now attach the other Arm/Leg the same way.
3. Align the holes in the backs of the arms with the brace on the rear of the Back Assembly (C). Put two
1 3/4" Bolts in the holes on either side. Add a Washer and a Cap Nut and hand tighten.
4. Make sure the right and left sides lower brace of Back Assembly (C) are fully seated in the slots and
start the two Wood Screws. Screw in the Wood Screws until they are tight and the heads are slightly
below the surface of the wood.
5. Place each Rocker into position with the spacer block in the rear. The longer 2 1/2" Bolts t through
the holes in the rear and the 1 3/4" Bolts are used in the front. Finally, using a at screwdriver and a pair
of pliers, tighten all cap nuts in the entire chair securely until the bolt heads begin to be pulled slightly into
the wood.
If you have problems in assembly, please call us and we will help you.
Care and Cleaning:
If this Chair is unnished, it must be totally protected by an outdoor/exterior rated stain or house paint BEFORE
being used outside. Exposure to any weather or even sun can cause rapid deterioration, cracking, warping,
splitting and discoloration of unnished wood.
If this Chair is painted, the nish is designed to provide long lasting protection when exposed to the harshness
of weather. But no matter how durable, painted wooden furniture should not be left outdoors continually. It is
best to store it inside when not in use. Even in mild conditions, painted wood furniture left outdoors will eventually
fade and show the effects of exposure to weather. To clean your painted furniture, use a mild detergent such as a
dishwashing liquid and a soft cloth. Never use any type of abrasive cleanser.
1. Please inspect all parts for damage
during shipping and for any missing
items. If you suspect that there may be
damage or a shortage, call us and we
will send replacement parts if needed. At
this time, visualize how the compo-
nents
t together per the above drawing and
make sure that you have everything
identied. You will need a standard phil-
lips screwdriver, a at head screwdriver
and a pair of pliers.
B
A2
A1
C
D
Left Side
Right Side
The arm support
blocks are to be
facing to the outside
of the chair.
Assembly Instructions For Child's
Adirondack Rocking Chair
Made in America
All of us hope that you and your little ones enjoy this Adirondack Rocking Chair for many years.
Please call us if you have any questions.