Assembly Instructions

Step 2

Step 1

Your Ottoman is ready for use.

Your Ottoman can only be used on a flat, level surface.

This Ottoman has multiple parts and may require up to 30 minutes to assemble. To give you

an overview of the Ottoman parts, the above picture is to help you put the various Ottoman

parts into perspective.

Please read through the instructions to familiarise yourself with the parts and steps before

assembly.

Position Ottoman(A) facedown on a clean, non-marring surface.

Install the Legs(B) into the bottom of the Ottoman(A) by placing a Plastic Washer(①) onto the

threaded stem of the Legs.

And then insert the threaded stem into the threaded mounting position at each Corner of the

Bottom of the Ottoman(A).

Tighten by turning the Legs clockwise.

Note: The use of Plastic Washer(①) are OPTIONAL and are especially useful to help alleviate

slight wobbles. Some Legs may need more than one Plastic Washer whilst some Legs may

not need any.

Position Ottoman right side up and test for stability on a Level Surface.

Add or remove Plastic Washer(①) where needed to achieve stability.

Ottoman(A)

Leg (B)

①

3 of 4