Instructions / Assembly

14
13
Page 8 of 10
Step 9:
Step 8:
Make sure all slats arched
like this when assembled
K
D
H
G
K
F
J
Use an Allen wrench (K) to connect the center leg (11) to
the center pipe (8) with M6 bolts (F) and flat washers (J).
Headboard
Footboard
Footboard
metal frame
Headboard
metal frame
Leave spacing
Leave spacing
First, use bolts (D) and nuts (H) to connect the side tube (8) to the hinge (4).
At this stage, do not fully tighten the bolts (D) to allow for some adjustment
between the headboard, pedals and the metal frame. After aligning each
part of headboard, pedal and metal frame, fully tighten all bolts (D).
LED light
LED light
K
G
H
D
J
×6
×6
×1
×1
×2
F
×2
11
8
11
11
4
8
14
13
12
12
12
15
Attach the plastic slat caps (13) to each
slat (12) at the side Then press down the
hole corresponding to the side pipe (8).
Attach the centre slat caps (14) between two slats
(12) at the centre Then press down the hole
corresponding to the side pipe (8).
Insert the Mattress Stopper (15) into
the hole corresponding to Cross
Rail for Metal Slat Frame (9)
9
×26
×13