Instructions / Assembly

BOX-1: 2+4+5+6

BOX-2: 1+3+7+ABCDE

Supporting plank x 1

Front and back seat frame

panels

Backrest

Step 1:

As shown in the ﬁgure,Connect and ﬁx the left and right handrails

with the front and rear frame plates with screws, gaskets and

connecting pieces

Back

Front

Step 2:

Step 3:

Note :The holes on both sides of the

connector are divided into round holes and

vertical holes. The round holes should be

connected with the front frame plate or the

rear frame plate, and the vertical holes should

be connected with the handrails. The four ﬁxed

points should follow this principle.

Insert the metal connecting pieces at

both ends of the center bar into the

connecting seats of the front and

rear frame plates

Lay the support plate ﬂat over the frame

round holes

vertical holes

First of all, find the

fabric cover of the 3 seat

cushions and put the seat

cushions into the cover as

shown in the picture to

complete the assembly of

③.

Back

Front

Left and right armrests

PAGE 1
B O X - 1 : 2+ 4+ 5+ 6 B O X - 2 : 1+ 3+ 7+ ABCD E Left and right armrests Backrest Back Front Supporting plank x 1 Front and back seat frame panels ! First of all, find the fabric cover of the 3 seat cushions and put the seat cushions into the cover as shown in the picture to complete the assembly of ③.
PAGE 2
Step 4: Insert backrest ver�cally into the frame,Note whether the connector is inserted 2 Step 5: As shown in the ﬁgure, lay down the sofa with the backrest on the ground, ﬁnd the four holes at the bo�om of the armrest, and turn the screws of the sofa feet into the holes clockwise un�l they cannot be rotated. E E E E Step 6: Straighten the sofa with feet installed, and place the cushions on the sofa in turn as shown in the ﬁgure.