Owner's Manual

16
IF YOUR CHILD HAS REACHED 100 CM, YOU CAN USE THE SEAT IN BOOSTER
MODE.
Harmony Juvenile Products advises that your child remains in a 5-point harness for
as long as possible per the height and mass requirements of the child restraint.
1. Loosen the harness system by pressing on the up-front metal harness adjuster
(UNDER THE FABRIC), and simultaneously pulling the shoulder straps towards
you.
2. Unbuckle harness by pressing on the RED buckle release button. Remove infant
insert cushion and crotch pad. Set aside.
3. To remove the harness pads: Undo the snaps on each harness pad and remove.
Set aside.
4. Undo the snaps on the backrest fabric cover and thread the crotch buckle
through the hole on the fabric seat cover
(18).
5. Hold the two buckle clips together and insert the two-piece buckle clip into
buckle until they ‘click’ into place
(19). Tuck harness straps, clips and crotch
buckle in the slots under fabric seat cover
(20, 21).
6. To reinstall harness system: repeat the previous steps in reverse order.
! ENSURE that the strap is COMPLETELY in the slot and the crotch strap is NOT
twisted.
7. Replace fabric seat cover and fabric crotch pad.
REMOVING/INSTALLING HARNESS
USING CHILD RESTRAINT IN BOOSTER MODE
(WITHOUT BUILT-IN HARNESS)
WARNING!
!
FAILURE TO REINSTALL THE HARNESS SYSTEM AND CROTCH STRAP
CORRECTLY COULD RESULT IN SERIOUS INJURY OR DEATH.