AL010 Micro Scooter Lift AL030 Power Tote for Manual Wheelchairs AL050 Micro Power Chair Lift
Unpackaging the Lift Check the contents of the box against the package check list to be sure that all parts are included with the lift that are required for proper installation. If any parts are missing or if any damage is noted, immediately contact your Harmar Dealer. DO NOT attempt to install or use the lift with any missing or damaged parts.
Vehicle Wiring Instructions Unwind the harness and lay it flat on the ground. One end of the harness has a black plug; this runs to the back of the vehicle. BEGIN ROUTING THE HARNESS AT THE VEHICLE BATTERY. Connect the black wire to the negative terminal of the battery. Do not connect the positive terminal yet. E IR KW AC L B K AC BL RE WI OR Top mount Side mount Run wiring harness under, or if possible, through the vehicle, using cable ties provided to secure the harness to the vehicle.
Hitch Adapters Before installing an outside lift on your vehicle the vehicle must be equipped with the correct hitch. If you are unsure whether your vehicle has, or can accept a hitch, contact your local hitch installer or visit www.hitch-web.com for vehicle hitch compatibility information. Please note, your lift comes equipped with a license plate hold light. To power this light vehicle must have a standard 4-contact trailer light harness. Contact your local hitch installer for more information.
Installing the Lift HITCH POST OMIT STABILIZER HITCH ADAPTER OMIT STABILIZER Measure from Hitch Bar to ground 15-17" 5-13" 13-15" 17-19"
Installing the Lift With Swing Away Option Measure from Hitch Bar to ground 4-12" 12-14" 14-16" 16-17"
Swing Away Operation
AL010 Lift Operation
Safety and Maintenence Keep hands feet and other objects clear of platform as it lowers to the ground. Always verify that scooter is securely held down to the lift before attempting to transport. On some scooters it may be necessary to temporarily move the steering tiller forward to clear the hold down arm as it lowers into the locked position Scooters equipped with pneumatic (air-inflated) tires must have properly inflated tires at all times.
AL030 Lift Operation
AL030 Safety and Maintenance Keep hands feet and other objects clear of platform as it lowers to the ground. Always verify that wheelchair is securely held down to the lift before attempting to transport. Wheelchairs equipped with pneumatic (air-inflated) tires must have properly inflated tires at all times. Improper tire inflation may change the hold-down force required. Use caution when driving over speed bumps, potholes, railroad tracks or other sudden road changes.
AL050 Power Chair Preperation There are 2 options on how to attach the strap hooks to the chair that are included with the lift. Anchor Plate: The Anchor Plate is a bar that is 20” long and 2 1/2” wide with 2 holes in each end. This plate will work with any chair that has a center seat post that attaches to the bottom of the seat. Attach the Anchor Plate by the following steps. 1. Remove the seat from the chair and turn it over. 2. Loosen the screws that attach the plate to the bottom of the seat.
AL050 Lift Operation 5 Raise platform with toggle switch, until motor's ratchet sound is heard.
AL050 Safety and Maintenance Keep hands feet and other objects clear of platform as it lowers to the ground. Always verify that power chair is securely held down to the lift before attempting to transport. Use caution when driving over speed bumps, potholes, railroad tracks or other sudden road changes. Failure to drive carefully and slowly over such obstacles can result in damage to your lift, vehicle or chair. Use care when entering steep driveways.
AL010, AL030 and AL050 Lift Adjustments
AL010 Micro MP
AL030 Power Tote 14 15 16 KEYSWITCH POLE REVERSING SWITCH ACTUATOR BATTERY 12V +
AL050 Micro Power Chair Lift 1 3 AL050 - MICRO POWER CHAIR LIFT 2 1 2 3 4 5 6 7 8 9 10 11 12 4 5 8 7 OR 6 TOGGLE SWITCH KEY SWITCH MOTOR COVER ACTUATOR OUTER TUBE INNER TUBE HITCH POST CLASS 2 HITCH ADAPTER CLASS 3 HITCH ADAPTER PLATFORM - AL050 STRAP ASSY PLATFORM ANGLE TUBE ALA12010 ALA12015 ALA12050 ALA10010 ALA0303 ALA0300 ALA129 AL126 ALA123 ALA0312 ALA69073 H05010 9 11 10 12 KEYSWITCH POLE REVERSING SWITCH ACTUATOR CIRCUIT BREAKER 12V + BATTERY VEHICLE HARNESS TRAILER PLUG MOTOR COVE
Teoubleshooting Guide Problem Lift does not operate Lift operates slowly Intermittent power to lift Hold-down will not stay upright or is difficult to move. Lift platform is difficult to move. There is a ratcheting sound when the lift goes all the way up or all the way down. There is excessive wire left over after connecting harness to vehicle. The license plate light does not work. The lift does not reach the ground when completely lowered. Lift bottoms out while entering driveways or going over bumps.
AL050 Mocro Power Chair Lift
