Operation Manual

14
It isn’t possible to “edit” a command within a macro. However, you
may erase the macro as follows:
1. Simultaneously press and hold the Mute Button and the Macro
Button containing the macro until the Program LED flashes.
2. Press the Surround Button to erase the macro.
Here are two macros that you may find useful when listening to an iPod
docked in The Bridge:
The purpose of the first macro is to access the DMP SETTING menu
while listening to The Bridge with one button press:
1. Simultaneously press and hold the M1(or other unused) Macro
Button and the Mute Button until the Program LED flashes.
2. Press the AVR Button (first command switches the remote to AVR
mode).
3. Press the OSD Button (second command activates the on-screen
menu system).
4. Press the Set Button (third command selects the INPUT SETUP
menu; this macro assumes the current source is The Bridge).
5. Press the
¤ Button three times (fourth, fifth and sixth commands
navigate to the GO TO DMP SETTING line).
6.
Press the Set Button again (seventh command selects the DMP
SETTING menu).
7. Press the Sleep Button to end the programming process. You have
now programmed the first macro, which will display the DMP SET-
TING menu after you have selected The Bridge as your source input.
After you have made your selections in the DMP SETTING menu, such
as turning on Repeat Playback or Shuffle mode, the second macro
enables you to exit the on-screen menu system and return the remote
to The Bridge mode, again with just one button press.
1. Simultaneously press and hold the M2 (or other unused) Macro
Button and the Mute Button until the Program LED flashes
.
2. Press the OSD Button (first command exits the on-screen menu system;
this macro assumes that you have not let the OSD time out).
3.
Press the
T
ape/The Bridge Input Selector twice (second and third
commands switch the selector to The Bridge mode and select
The Bridge as the source).
This step is required even if you already
switched the selector
’
s mode before programming the macro
.
4. Press the Sleep Button to end the programming process. You have
now programmed the second macro
,
which may be used after run
-
ning the first macro to exit the OSD system quickly and retur
n the
remote’s operation to The Bridge.
Resetting the Remote
To reset the remote to its factory defaults, simultaneously press and
h
old any Input Selector and the “0” Numeric Key. When the LED flashes
amber, enter the code “333”. When the green LED goes out, the remote
will have been fully reset.
ADVANCED FUNCTIONS
RCP4 remote OM.qxd 11/29/06 3:17 PM Page 14