Operation Manual

1111
PROGRAMMING SOURCES
Table 1 – Remote Control Codes
*
Do not reprogram the DVD Source selector unless you are replacing
the DVD player included in the CP 45 system with another product.
7. After you have programmed a code set to operate a device, test
the functions to see which ones may be missing or not operating
correctly
. You may “learn” individual key codes if you have the
device’s original remote control by following the procedure below. If
you no longer have the device’s original remote, you may still connect
it to the AVR 245. You may wish to consider purchasing Harman
Kardon’s optional TC 30 activity-based remote, which is programmed
by accessing a large database of product codes on the Internet.
Most of the button labels on the remote describe the button’s function
when used to control the
AVR 245 (white or gray labels) or DVD 37
(blue labels). However, the button may perform a very different function
when used to control another device. Refer to the Remote Control
Function List, Table A1 in the Appendix, for a list of each button’s
functions with the various product types.
If you wish,
you may program macros
,
which are preprogrammed
code sequences that execute many code commands with a single
button press
.
You may also program “punch-through” codes, which
allow the remote to operate the volume
,
channel or transport controls
of another device without having to switch the remote’s device mode.
See page 13 for instructions on these advanced programming
functions
.
NOTE: The RCP 4 remote is preprogrammed to operate the
transport controls of the DVD 37 when the
A
VR or
VID2 or
VID3
device
is selected. Y
ou may change this punch-through program
-
ming at any time, as explained in the Advanced Functions section.
Source Input Product Type Remote Control Code
(
circle one)
Video 1 VCR, PVR
V
ideo 2 Cable, Satellite
Video 3 TV
Video 4 TV
HDMI 1 DVD, VCR, Cable, Satellite
HDMI 2 DVD, VCR, Cable, Satellite
DVD
*
DVD
CD CD, CD-R
Tape Cassette
RCP4 remote OM.qxd 11/29/06 3:17 PM Page 11