Operation Manual

27 SYSTEM CONFIGURATION
System Configuration
As indicated in the menu, when you start the
process a special test tone will be heard
through the subwoofer or front/left right speak-
ers, depending on your system’s configuration.
Press the
Volume Up Button until the
sound from the subwoofer or front speakers’
low-frequency drivers sounds distorted or
crackly. At that point IMMEDIATELY press the
Set Button o.
At this point the maximum setting will be
entered and the test noise will stop. Press the
⁄
/
¤
Buttons mp so that the on-screen
›
cursor is next to BACK TO MASTER
MENU
. Press the Set Button o to return
to the
MASTER MENU.
When all settings and adjustments have been
made, press the
OSD Button v to return to
normal operation of the AVR.
Once the settings outlined on the previous
pages have been made, the AVR 8000 is ready
for operation. While there are some additional
settings to be made, these are best done after
you have had an opportunity to listen to a vari-
ety of sources and different kinds of program
material. These advanced settings are described
on pages 36 to 37 of this manual. In addition,
any of the settings made in the initial configu-
ration of the unit may be changed at any time.
As you add new or different sources or speak-
ers, or if you wish to change a setting to better
reflect your listening taste, simply follow the
instructions for changing the settings for that
parameter as shown in this section.
Having completed the setup and configuration
process for your AVR 8000, you are about
to experience the finest in music and home
theater listening. Enjoy!
42