Operation Manual

MULTIROOM OPERATION
MULTIROOM OPERATION 37
When the multiroom system is turned on, the input
selected using the multiroom menu will be fed to the
Multiroom Audio Outputs j on the rear panel as
well as the A-BUS Jack ∞.The volume will be as set
in the previous selection, although it may also be
adjusted using an optional IR sensor and the Zone II
remote in the remote location, or the A-BUS keypad,
or on the optional audio power amplifier connected to
the Multiroom Audio Outputs j.
Once the multiroom system is turned on, it will remain
on even if the AVR 525 is placed in the Standby
mode in the main room by pressing the Power Off
Button
å or the System Power Control 2 on
the front panel.To turn off the multiroom system, even
when the AVR is in Standby mode in the main listening
room, press the Multiroom Button and then
the Set Button p. Press the
⁄
/
¤
Buttons n
so that the Multiroom Indicator D in the Main
Information Display ˜ goes out, and the Main
Information Display ˜ or OSD will display
MULTI OFF. Press the Set Button p to enter
the setting and turn the unit off.
Even when the AVR 525 is turned off in the main
room, the multiroom system may be turned on at any
time by pressing the Multiroom Button ,or any
of the Selector Buttons
∫ç∂ in the
remote room.
39
39