Operation Manual

ManualsBrandsHarman Kardon ManualsAudioAVR35

Front Panel Controls

1 Main Power Switch: Press this

button to apply power to the AVR35.

When the switch is pressed in the

unit is placed in a Standby mode,

as indicated by the amber LED 3

surrounding the System Power

control 2. This button MUST be

pressed in to operate the unit. To

turn the unit off and prevent the use

of the remote control, this switch

should be pressed until it pops out

from the front panel so that the word

“OFF” may be read at the top of the

switch.

NOTE: In normal operation this

switch is left in the “ON” position.

2 System Power Control: When

the Main Power Switch

is “ON,”

press this button to turn on the

AVR35; press it again to turn the unit

off. Note that the Power Indicator

surrounding the switch

will turn

green when the unit is on.

3 Power Indicator: This LED will

illuminate in amber when the unit is

in the Standby mode to signal that

the unit is ready to be turned on.

When the unit is in operation, the

indicator will turn green.

4 Headphone Jack: This jack may

be used to listen to the AVR35’s out-

put through a pair of headphones.

Be certain that the headphones

have a standard

⁄4" stereo phone

plug.

5 Bass Control: Turn this control to

modify the low-frequency output of

the left/right channels by as much as

±10dB. Set this control to a suitable

position for your taste and room

acoustics.

6 Treble Control: Turn this control

to modify the high-frequency output

of the left/right channels by as much

as ±10dB. Set this control to a

suitable position for your taste and

room acoustics.

7 Balance Control: Turn this

control to change the relative volume

for the front left/right channels.

NOTE: For proper operation of the

surround modes this control should

be at the midpoint, or “12 o’clock”

position.

8 Video 3 Inputs: These

audio/video inputs may be used

for temporary connection of video

games, camcorders, digital still

cameras or portable audio products.

To select a source connected to

these jacks, press the Vid 3 Input

Selector @.

9 Tape Selector: Press this button

to select the device connected to

the Tape Monitor jacks a as the

listening source. The previously

selected source will continue to

show in the Information Display

, and the red LED above the

button will illuminate to remind you

that you are listening to the tape

monitor output.

) CD: Press this button to select

the device connected to the CD

Input jacks ∞ as the listening

source.

! DVD Input: Press this button to

select the device connected to the

DVD Play jacks § as the listening

and viewing source.

@ Video Input Selectors: Press

one of these buttons to select a

source connected to the rear panel

Audio/Video inputs £›, or the

front panel Video 3 inputs 8.

# AM/FM: Press this button to

select the tuner as the AVR35’s input

source. When it is first pressed the

last station tuned will be heard.

Press it again to change between

AM and FM bands.

$ Sleep Button: Press this button

to place the unit in the Sleep mode.

After the time shown in the display,

the AVR35 will automatically go into

the Standby mode. Each press of

the button changes the time until

turn-off in the following order:

% Tuning Button: Press the left

side of the button to tune lower

frequency stations and the right side

of the button to tune higher frequency

stations. When a station with a strong

signal is tuned, the TUNED indicator

R will illuminate in the Information

Display

. A brief (1/2 second)

press of the button will manually

tune to the next frequency incre-

ment, while pressing and holding

the button for a longer period will

automatically tune to the next station

with a signal strong enough for

acceptable reception.

^ Preset Scan: Press this button

to automatically scan through the

stations that have been programmed

in the AVR35’s memory. The tuner

will play five seconds of each station

before moving to the next preset

station. To stop the scan when the

desired station is heard, press the

button again. (See page 26 for more

information on the tuner memory

system.)

min

OFF

AVR35 om (H) 2/5/99 10:41 AM Page 5