Operation Manual

Programming the Remote
To find out what function a particular
button has for a specific device, find the
button on the diagram on this page, and
then look at the Function List (pages 32
and 33) in the column for the device you
are controlling. For example, button
number 29 is the Tuning Down button for
the AVR35, but it is the “Rewind” button
for many VCRs. Button number 33 is the
Preset Tune Down button for the AVR35,
the “Reverse Skip” button for CD players
and the “Page Down” button for some
cable boxes.
IMPORTANT NOTE: The numbers used
on these pages to determine the function-
ality of a remote button are used for this
purpose only. DO NOT confuse them with
the numbering used in the rest of this
manual to identify the button functions
for controlling the AVR35.
Notes on Using the AVR35 Remote With
Other Devices.
• Manufacturers may use different code
sets for the same product category. For
that reason, it is important that you
check to see if the code set you have
entered operates as many controls as
possible. If it appears that only a few
functions operate, check to see if
another code set will work with more
buttons.
• When a button is pressed on the AVR35
remote, the red light under the
Device Control Selector c for
the product being operated should
flash briefly. If the Device Control
Selector flashes for some, but not all
buttons for a particular product, it
does NOT indicate a problem with the
remote, but rather that no function is
programmed for the button being
pushed.
Macro Programming
The Power button may be programmed to
send out a sequence of up to eight com-
mands when it is pushed. This enables
you to turn on a number of products,
and to have a program source turn to a
favorite channel or any other command.
To program a macro into the Power
button, follow these steps:
1. Press either the AVR button b or
the SAT/CBL Device Selector
button c and the Mute button
` at the same time until the red
light under the Device Control
Selector turns on.
2. Press the Power button d and
note that the Device Control Selector
will blink once.
3. Enter up to eight macro steps, by
pressing the Device Control button
and then the function button for each
step you wish to enter. To enter the
“Power On/Off” command during
macro programming, press the Mute
button `. DO NOT press the actual
Power Button.
4. When the eight steps have been
entered, press the Channel
⁄
/
¤
buttons f to enter the commands.
The red light under the
Device
Control Selector will blink twice
and then turn off.
30
AVR 35
21
4
5
7
9
1110
12
16
13
1817
19 20 21 22
26
30292827
31
35 36 37 38 39
4443424140
45
47 48 49 50
46
32 33 34
252423
1514
6
8
3
AVR35 om (H) 2/5/99 10:41 AM Page 30