Operation Manual

System Configuration
18
When LARGE is selected, a full-
range output will be sent to the
front left and right outputs, and
NO low-frequency signals will be
sent to the subwoofer output.
5. When you have completed your
selection for the front channel, press
the Set button j˜, and then
press the
⁄
/
¤
buttons h on the
remote or the Selector buttons¸
on the front panel to change the
display to CEN SPEAKER.
6. Press the Set button j˜again,
and use the
⁄
/
¤
buttons h on
the remote, or the Selector buttons
¸ on the front panel, to select the
option that best describes your system
based on the speaker definitions
shown above.
When CEN SP SMALL is select-
ed, low-frequency center-channel
sounds will be sent to the subwoofer
output only. Note that if you choose
this option and there is no sub-
woofer connected, you will not hear
any low-frequency sounds from the
center-channel speaker.
When CEN SP LARGE is select-
ed, a full-range output will be sent
to the center speaker output, and
NO center-channel signal will be
sent to the subwoofer output.
When CEN SP NONE is selected,
no signals will be sent to the center-
channel output. The receiver will
operate in a “phantom” center-
channel mode and center-channel
information will be sent to the left-
and right-front-channel outputs.
7. When you have completed your
selection for the center channel, press
the Set button j˜, and then
press the
⁄
/
¤
buttons h on the
remote or the Selector buttons¸
on the front panel to change the
display to SUR SPEAKER.
8. Press the Set button j˜again,
and then use the
⁄
/
¤
buttons h
on the remote or the Selector
buttons¸ on the front panel to
select the option that best describes
your system based on the speaker
definitions shown above.
When SUR SP SMALL is select-
ed, low-frequency surround chan-
nel sounds will be sent to the
subwoofer output only. Note that if
you choose this option and there is
no subwoofer connected, you will
not hear any low-frequency sounds
from the surround speaker.
When SUR SP LARGE is selected, a
full-range output will be sent to the
surround-channel outputs, and NO
surround-channel signals will be sent
to the subwoofer output.
When SUR SP NONE is selected,
surround-sound information will be
split between the front-left and front-
right outputs. Note that for optimal
performance when no surround
speakers are in use, the Dolby 3
Stereo mode should be used instead
of Dolby Pro Logic.
9. When you have completed your
selection for the surround channel,
press the Set button j˜, and
then press the
⁄
/
¤
buttons h on
the remote or the Selector buttons¸
on the front panel to change the display
to SÐW SPEAKER.
10. Press the Set button j˜, and
then press the
⁄
/
¤
buttons h on
the remote or the Selector buttons¸
on the front panel to select the option
that best describes your system.
Select S-W SP ON if a subwoofer
is connected to your system.
Select S-W SP OFF if a subwoofer is
NOT connected to your system. Note
that when no subwoofer is selected,
low-frequency sounds below 100Hz
will be sent to the front left/right
speakers, provided that the selection
in step 4, above, has been set to
LARGE. Otherwise, no low-frequency
sounds will be heard. This option is
not available when the front, center or
surround speakers are set to SMALL.
AVR35 om (H) 2/5/99 10:41 AM Page 18