Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Information on low outside temperatures
Refuel your vehicle with as much winter diesel
fuel as possible at the beginning of winter.
Before changing over to winter diesel fuel, the
fuel tank should be empty, if possible. When first
refuelling with winter diesel fuel, only refuel
using a small amount, e.g. to reserve level. The
fuel tank can be filled as usual when next refuel‐
ling.
Further information on fuel can be obtained at a
filling station or a qualified specialist workshop.
Tank content and fuel reserve
Missing values were not available at the time of
going to press.
The total capacity of the fuel tank may vary,
depending on the vehicle equipment.
Model Total capacity
All models
of which reserve
fuel
All models
AdBlue
®
Notes on AdBlue
®
Observe the notes on operating fluids
(/ page 564).
AdBlue
®
is a water-soluble fluid for the NOx
exhaust gas aftertreatment of diesel engines.
It may be improper or punishable in some coun‐
tries to operate a vehicle that uses no AdBlue
®
or one that does not comply with the specifica‐
tions of these operating instructions.
*
NOTE Malfunctions due to the dilution of
AdBlue
®
or the use of additive-enhanced
AdBlue
®
The function of the NOx exhaust gas after‐
treatment can be impaired by the use of
unsuitable denoxification agents.
#
Only use AdBlue
®
in accordance with
ISO 22241.
#
Do not dilute AdBlue
®
with water.
#
Do not use additive-enhanced AdBlue
®
.
*
NOTE Damage and malfunctions due to
impurities in AdBlue
®
Consequences of impurities in AdBlue
®
:
R
increased emission values
R
damage to the catalytic converter
R
NOx exhaust gas aftertreatment malfunc‐
tions
#
Avoid impurities in AdBlue
®
.
AdBlue
®
residues crystallise after a period of
time, and contaminate the surfaces with which
they come into contact. Clean the dirty surfaces
with water as soon as possible.
When you open the AdBlue
®
tank, small
amounts of ammonia vapour may escape. Do
not inhale any ammonia vapours that may be
released. Only fill the AdBlue
®
tank in well-venti‐
lated areas.
AdBlue
®
capacity
Missing values were not available at the time of
going to press.
568
Technical data