Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Notes on technical data
The technical data was determined in accord‐
ance with EU Directives. The data stated only
applies to vehicles with standard equipment. You
can obtain further information from a Mercedes-
Benz Service Centre.
Only for certain countries: you can find vehi‐
cle-specific vehicle data in the COC documents
(CERTIFICATE OF CONFORMITY). These docu‐
ments are delivered with your vehicle.
On-board electronics
Notes on tampering with the engine elec‐
tronics
*
NOTE Premature wear through improper
maintenance
Improper maintenance may cause vehicle
components to wear more quickly and the
vehicle's operating permit may be invalida‐
ted.
#
Always have work on the engine elec‐
tronics and related components carried
out at a qualified specialist workshop.
*
NOTE Increased wear and tear or dam‐
age caused by measures undertaken to
increase performance
Engine management measures undertaken to
increase performance can lead to increased
wear and tear or damage to the drive system.
#
Do not undertake engine management
measures to increase performance.
Two-way radios
Notes on fitting two-way radios
&
WARNING Risk of accident due to
improper work on two-way radios
The electromagnetic radiation from two-way
radios can interfere with the on-board elec‐
tronics if RF transmitters are manipulated or
retrofitted incorrectly.
This could jeopardise the operating safety of
the vehicle.
#
You should have all work on electrical
and electronic components carried out
at a qualified specialist workshop.
&
WARNING Risk of accident from incor‐
rect operation of two-way radios
If you operate two-way radios incorrectly in
the vehicle, the electromagnetic radiation
could interfere with the on-board electronics,
e.g.:
R
if the two-way radio is not connected to
an exterior aerial
R
if the exterior aerial is not correctly
mounted or is not of low reflection
This could jeopardise the operating safety of
the vehicle.
#
Have the low-reflection exterior aerial
fitted at a qualified specialist workshop.
506
Technical data