Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Position of jack support points
&
WARNING Risk of injury from incorrect
positioning of the jack
If you do not position the jack correctly at
the appropriate jacking point of the vehicle,
the jack could tip with the vehicle raised.
#
Only position the jack at the appropri‐
ate jacking point of the vehicle. The
base of the jack must be positioned
vertically under the jacking point of the
vehicle.
*
NOTE Vehicle damage from the jack
If you do not position the jack correctly at
the appropriate jack support point of the
vehicle, the jack could tip over with the vehi‐
cle raised.
#
The jack is designed exclusively for
jacking up the vehicle at the jack sup‐
port points.
#
Take the ratchet ring spanner out of the tyre-
change tool kit and place it on the hexagon
nut of the jack so that the letters "AUF" are
visible.
#
Position jack 2 at jack support point 1.
#
Turn ratchet ring spanner 3 clockwise until
jack 2 sits completely on jack support point
1 and the base of the jack lies evenly on
the ground.
#
Continue to turn ratchet ring spanner 3
until the tyre is raised a maximum of 3 cm
off the ground.
#
Loosen and remove the wheel (/ page 503).
502
Wheels and tyres