Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Display messages
Possible causes/consequences and M Solutions
5
Engine oil pressure Stop
Switch off engine
* Display message only for certain engines:
The oil pressure is too low.
*
NOTE Engine damage caused by driving with insufficient oil pressure
#
Avoid driving with insufficient oil pressure.
#
Stop the vehicle immediately in accordance with the traffic conditions. Do not continue driving.
#
Consult a qualified specialist workshop.
5
Engine oil level cannot be
measured
* The electrical connection to the oil level sensor has been interrupted or the oil level sensor is faulty.
#
Consult a qualified specialist workshop.
Warning and indicator lamps
Overview of indicator and warning lamps
Some systems will perform a self-test when the
ignition is switched on. Some indicator and
warning lamps may briefly light up or flash. This
behaviour is non-critical. These indicator and
warning lamps indicate a malfunction only if they
light up or flash after the engine has been star‐
ted or during a journey.
634
Display messages and warning/indicator lamps