Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
4MATIC vehicles
#
Make sure that the front and rear axles come
to rest on the same transportation vehicle.
*
NOTE Damage to the drivetrain due to
incorrect positioning
#
Do not position the vehicle above the
connection point of the transport vehi‐
cle.
Towing eye storage location
Towing eye 1 is located with the vehicle tool kit
under the boot floor.
Installing the towing eye
#
Press the mark on cover 1 inwards and
remove.
#
Screw in the towing eye clockwise as far as it
will go and tighten.
Vehicles with a trailer hitch: vehicles with a
trailer hitch do not have a rear bracket for the
Breakdown assistance
485