Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Display messages
Possible causes/consequences and M Solutions
Û
48 V battery See Owner's
Manual
* The 48 V on-board electrical system has function restrictions. Convenience functions may be restricted.
#
Consult a qualified specialist workshop immediately.
Ý
Please wait 48 V battery
charging
* The 48 V battery is discharged. You have switched on the ignition while the 12 V battery was being charged with a
suitable charger or while another vehicle was providing starting assistance.
The discharged 48 V battery is charged automatically via the voltage converter. After a few minutes, the driver's
display will show the display message Motor can be started again.
#
Start the engine.
#
Drive the vehicle for a while to charge the 12 V battery and the 48 V battery after disconnecting the charger
from the vehicle.
If the Motor can be started again display message does not appear after a few minutes:
#
Try to start the engine again.
#
If the engine does not start, consult a qualified specialist workshop.
Cannot start engine See
Owner's Manual
* The charge level of the 48 V battery is too low. You can no longer start the engine.
#
Switch off electrical consumers that are not required.
Display messages and warning/indicator lamps
625