Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Display messages
Possible causes/consequences and M Solutions
#
Switch on the engine to
charge the 12 V battery
* The engine is off and the charge level of the 12 V battery is too low.
#
Switch off electrical consumers that are not required.
To charge the 12 V battery:
#
Leave the engine running for a few minutes, or drive an extended distance.
#
Stop the vehicle Leave the
engine running to charge
the 12 V battery
* The battery charge level is too low.
#
Stop the vehicle immediately in accordance with the traffic conditions. Do not continue driving.
#
Leave the engine running.
#
Wait until the display message disappears before pulling away.
#
If the display message does not disappear: consult a qualified specialist workshop.
Û
Stop vehicle See Owner's
Manual
* The 48 V on-board electrical system is malfunctioning.
#
Stop the vehicle immediately in accordance with the traffic conditions. Do not continue driving.
#
Switch off the engine.
#
Consult a qualified specialist workshop.
624
Display messages and warning/indicator lamps