Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Display messages
Possible causes/consequences and M Solutions
#
Reduce the vehicle speed considerably before taking a curve.
#
Avoid sudden steering movements.
#
Continue driving carefully and do not exceed 80 km/h.
#
If possible, stop the vehicle in accordance with the traffic conditions and switch the ignition off and on again.
#
If the display message still appears, consult a qualified specialist workshop.
ä
Fault Stop
* There is a serious malfunction affecting the hydraulics of the E-ACTIVE BODY CONTROL system.
The system is deactivated.
*
NOTE The vehicle's driving characteristics have changed significantly.
#
Stop the vehicle immediately in accordance with the traffic conditions. Do not continue driving.
#
Stop the vehicle immediately in accordance with the traffic conditions. Do not continue driving.
#
Consult a qualified specialist workshop.
É
STOP Vehicle level too low
* You have pulled away despite the vehicle level being too low.
#
Stop the vehicle in accordance with the traffic conditions.
The vehicle will be raised to the selected vehicle level.
#
Wait until the display message disappears before pulling away.
If the display message does not disappear and a warning tone also sounds, AIRMATIC is malfunctioning:
Display messages and warning/indicator lamps
607