Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Display messages
Possible causes/consequences and M Solutions
!
Turn on the ignition to
release the parking brake
*
The red ! indicator lamp is lit.
You have attempted to release the electric parking brake with the ignition switched off.
#
Switch on the ignition.
J
Brake immediately
* A malfunction has occurred while the HOLD function was activated.
A horn may also sound at regular intervals.
You cannot start the engine.
#
Immediately depress the brake pedal firmly until the display message disappears.
You can restart the engine.
J
Check brake fluid level
* There is insufficient brake fluid in the brake fluid reservoir.
&
WARNING Risk of an accident due to low brake fluid level
If the brake fluid level is too low, the braking effect and the braking characteristics may be impaired.
#
Stop the vehicle as soon as possible, paying attention to road and traffic conditions. Do not continue driv‐
ing.
#
Consult a qualified specialist workshop.
#
Do not top up the brake fluid.
Display messages and warning/indicator lamps
601