Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Display messages
Possible causes/consequences and M Solutions
*
The yellow ! indicator lamp is lit and the red ! indicator lamp is flashing. The electric parking brake is mal‐
functioning.
The electric parking brake could not be applied or released.
#
Switch the ignition off and switch it back on.
To apply:
#
Release and then apply the electric parking brake manually (/ page 201).
To release:
#
Apply and then release the electric parking brake manually.
If it is not possible to apply the electric parking brake or the red ! indicator lamp continues to flash:
#
Do not continue driving. Consult a qualified specialist workshop.
#
Where necessary, also secure the parked vehicle against rolling away.
*
The yellow ! indicator lamp is lit and the red ! indicator lamp flashes for approximately ten seconds after
the electric parking brake has been applied or released. It then remains lit or goes out. The electric parking brake is
malfunctioning.
If the charge level is too low:
#
Charge the 12 V battery.
To apply:
Display messages and warning/indicator lamps
599