Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Display messages
Possible causes/consequences and M Solutions
+
Top up coolant See Own-
er’s Manual
* The coolant level is too low.
*
NOTE Engine damage due to insufficient coolant
#
Avoid long journeys with insufficient coolant.
#
Add coolant (/ page 460).
#
Have the engine cooling system checked at a qualified specialist workshop.
ÿ
Coolant Stop vehicle
Switch engine off
* The coolant is too hot.
#
Stop the vehicle immediately in accordance with the traffic conditions and switch off the engine.
&
WARNING Danger of burns when opening the bonnet
If you open the engine bonnet when the engine has overheated or during a fire in the engine compartment, you
could come into contact with hot gases or other escaping operating fluids.
#
Before opening the bonnet, allow the engine to cool down.
#
In the event of a fire in the engine compartment, keep the engine bonnet closed and call the fire service.
#
Wait until the engine has cooled down.
#
Make sure that the air supply to the radiator is not obstructed.
#
Avoiding high loads on the engine, drive to the nearest qualified specialist workshop. In doing so, ensure that
the coolant temperature display remains below 120 °C.
592
Display messages and warning/indicator lamps