Users Manual Part 5
Table Of Contents
- Wheels and tyres
- Notes on noise or unusual handling characteristics
- Notes on regularly inspecting wheels and tyres
- Notes on snow chains
- Activating or deactivating snow chain mode
- Tyre pressure
- Wheel change
- Notes on selecting, fitting and replacing tyres
- Notes on interchanging wheels
- Notes on storing wheels
- Overview of the tyre-change tool kit
- Preparing the vehicle for a wheel change
- Removing and fitting hub caps
- Raising the vehicle when changing a wheel
- Removing a wheel
- Fitting a new wheel
- Lowering the vehicle after a wheel change
- Emergency spare wheel
- Technical data
- Display messages and warning/indicator lamps
- Index
Observe the additional following points during
starting assistance:
R
Starting assistance may only be provided
using vehicles, batteries or other jump start
devices with a nominal voltage of 12 V.
R
The vehicles must not touch.
R
Vehicles with a petrol engine: jump-start
the vehicle only when the engine and exhaust
system are cold.
Starting assistance and charging the 12 V
battery
Preparing starting assistance/the charging
process
#
Secure the vehicle by applying the electric
parking brake.
#
Select transmission position j.
#
Switch off the ignition and all electrical con‐
sumers.
#
Open the bonnet.
#
Open cover 1 of the positive contact.
Starting assistance
#
Connect the positive contacts of the vehicles
with the jump lead. Start with your own vehi‐
cle first.
#
Start the engine of the donor vehicle and run
it at idling speed.
#
Connect negative terminal 2 of the donor
battery to the earth point of your vehicle
480
Breakdown assistance