Users Manual Part 5

#
Have the brake fluid renewed at the
specified intervals.
Have the brake fluid regularly replaced at a
qualified specialist workshop.
Only use a brake fluid approved by Mercedes-
Benz according to MB-Freigabe or MB-Approval
331.0.
Coolant
Notes on coolant
Observe the notes on operating fluids
(/ page 564).
&
WARNING Risk of fire‑ and injury from
antifreeze
If antifreeze comes into contact with hot
component parts in the engine compart‐
ment, it may ignite.
#
Allow the engine to cool down before
you top up the antifreeze.
#
Make sure that no antifreeze spills out
next to the filler opening.
#
Thoroughly clean the antifreeze from
component parts before starting the
vehicle.
*
NOTE Damage caused by incorrect cool‐
ant
#
Only add coolant that has been pre‐
mixed with the required antifreeze pro‐
tection.
Information on coolant is available at the fol‐
lowing locations:
R
in the Mercedes-Benz Specifications for
Operating Fluids 310.1
-
at https://bevo.mercedes-benz.com
-
in the Mercedes-Benz BeVo App
R
at a qualified specialist workshop
*
NOTE Overheating at high outside tem‐
peratures
If an inappropriate coolant is used, the
engine cooling system is not sufficiently pro‐
tected against overheating and corrosion at
high outside temperatures.
#
Always use coolant approved by
Mercedes-Benz.
#
Observe the instructions in the
Mercedes-Benz Specifications for Oper‐
ating Fluids 310.1.
Have the coolant regularly replaced at a qualified
specialist workshop.
The proportion of corrosion inhibitor/antifreeze
concentrate in the engine cooling system should
be:
R
a minimum of 50% (antifreeze protection
down to approximately -37 °C)
R
a maximum of 55% (antifreeze protection
down to -45 °C)
Notes on windscreen washer fluid
Observe the notes on operating fluids
(/ page 564).
Technical data
571