Users Manual Part 3
Table Of Contents
- Climate control
- Overview of climate control systems
- Operating the climate control system
- Switching climate control on/off
- Switching climate control on/off via the rear operating unit
- Calling up the air conditioning menu
- Activating/deactivating the A/C function via the multimedia system
- Setting climate control to automatic mode
- Setting climate control to automatic mode via the rear operating unit
- Overview of the air distribution settings
- Setting the air distribution
- Setting the footwell temperature
- Setting climate control for the rear passenger compartment (multimedia system)
- Activating/deactivating the climate control synchronisation function via the multimedia system
- Demisting the windows
- Switching air-recirculation mode on/off
- Switching residual heat on/off
- Switching residual heat on/off via the rear operating unit
- Activating/deactivating ionisation
- Fragrance system
- Information on the windscreen heater
- Stationary heater/ventilation
- Air vents
- Driving and parking
- Driving
- DYNAMIC SELECT switch
- Automatic transmission
- Function of the 4MATIC
- Refuelling
- Parking
- Driving and driving safety systems
- Driving systems and your responsibility
- Information on vehicle sensors and cameras
- Overview of driving systems and driving safety systems
- Function of ABS
- Function of BAS
- Function of ESP®(Electronic Stability Program)
- Activating/deactivating ESP®(Electronic Stability Program)
- Function of ESP®Crosswind Assist
- Function of ESP®trailer stabilisation
- Function of EBD
- Function of STEER CONTROL
- Function of Active Brake Assist
- Setting Active Brake Assist
- Function of Adaptive Brake Lights
- Cruise control and limiter
- Active Distance Assist DISTRONIC
- Function of Active Speed Limit Assist
- Function of route-based speed adaptation
- Setting route-based speed adaptation
- Active Steering Assist
- Function of Active Lane Change Assist
- Activating/deactivating Active Lane Change Assist
- Function of Active Emergency Stop Assist
- Function of Active Traffic Jam Assist
- Activating/deactivating Active Traffic Jam Assist
- Function of Hill Start Assist
- HOLD function
- AIRMATIC
- E-ACTIVE BODY CONTROL
- Parking Assist PARKTRONIC
- Reversing camera
- 360° Camera
- Active Parking Assist
- ATTENTION ASSIST
- Traffic Sign Assist
- Traffic Light Assistant
- Blind Spot Assist and Active Blind Spot Assist with exit warning
- Active Lane Keeping Assist
- Trailer hitch
- Bicycle rack function
- Vehicle towing instructions
- Instrument Display and on-board computer
Information on collision detection on a
parked vehicle
If a collision is detected when the tow-away pro‐
tection is primed on a locked vehicle, you will
receive a notification in the multimedia system
when you switch on the ignition.
You will receive information about the following
points:
R
The area of the vehicle that may have been
damaged.
R
The force of the impact.
The following situations can lead to inadvertent
activation:
R
The parked vehicle is moved, e.g. in a two-
storey garage.
%
Deactivate tow-away protection in order to
prevent inadvertent activation. If you deacti‐
vate tow-away protection, collision detection
will also be deactivated.
You can permanently deactivate the collision
detection via the multimedia system
(/ page 202).
System limits
Detection may be restricted in the following sit‐
uations:
R
the vehicle is damaged without impact, e.g. if
an outside mirror is torn off or the paint is
damaged by a key
R
an impact occurs at low speed
R
the electric parking brake is not applied
Setting collision detection on a parked vehi‐
cle (MMS)
Multimedia system:
4
©
5
Settings
5
Vehicle
5
Collision notification
#
Activate or deactivate the function.
Activating or deactivating the collision pho‐
tos function
Please note possible legal restrictions in some
countries regarding automatic recording of the
vehicle surroundings.
#
Activate or deactivate Collision photos.
Transferring the collision photos with the
Mercedes me App
#
Select Upload collision photos.
#
Scan the QR code on the central display with
the Mercedes me App.
The encrypted collision photos will then be
uploaded to Mercedes me.
%
Any device that can scan QR codes can be
used to view the collision photos in the
Mercedes me App.
Copying the collision photos onto a USB
flash drive
#
Connect a USB flash drive (/ page 425).
#
Select Manage collision photos.
#
Select Copy (USB).
All collision photos are copied onto the USB
flash drive.
Deleting collision photos
#
Select Manage collision photos.
#
Select Delete.
All collision photos will be deleted.
202
Driving and parking