Users Manual Part 3

R
The vehicle as well as persons and objects
are located outside the range of movement
of the door.
#
Press the programming button on the door
drive unit.
Initiate the next step within approximately
30 seconds.
#
Press previously programmed button 1, 2
or 3 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
%
Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
#
Check if the transmitter frequency of remote
control 5 is supported.
#
Replace the batteries in remote control 5.
#
Hold remote control 5 at various angles
from a distance of 1 cm to 8 cm front of the
inside rearview mirror. You should test every
position for at least 25 seconds before trying
another position.
#
Hold remote control 5 at the same angles
at various distances in front of the inside rear
view mirror. You should test every position
for at least 25 seconds before trying another
position.
#
Note that some remote controls transmit
only for a limited period, press button 6 on
remote control 5 again before transmission
ends.
#
Align the aerial line of the door opener unit
with the remote control.
%
Support and additional information on pro‐
gramming:
R
On the HomeLink
®
Hotline on (0) 08000
466 354 65 or [phone].
R
On the Internet at https://
www.homelink.com.
Opening or closing the garage door
Requirements:
R
The corresponding button is programmed to
operate the door.
#
Press and hold buttons 1, 2 or 3 until
the door opens or closes.
#
If indicator lamp 4 flashes yellow after
approximately 20 seconds: press and hold
the previously pressed button again until the
door opens or closes.
Clearing the garage door opener memory
#
Press and hold buttons 1 and 3.
Indicator lamp 4 lights up yellow.
#
If indicator lamp 4 flashes green: release
buttons 1 and 3.
The entire memory has been deleted.
Driving and parking
199