Users Manual Part 3

#
Never leave the engine or, if present,
the auxiliary heating running in an
enclosed space without sufficient venti‐
lation.
&
WARNING Risk of injury when opening
or closing a door with the garage door
opener
When you operate or program the door with
the integrated garage door opener, persons
in the range of movement of the door may
become trapped or be struck by the door.
#
Always make sure that nobody is within
the range of movement of the door.
Requirements:
R
The vehicle has been parked outside the
garage or outside the range of movement of
the door.
R
The engine is switched off.
R
The ignition is switched on.
%
The garage door opener function is always
available when the ignition is switched on.
#
Press and hold button 1, 2 or 3 that you
wish to program.
Indicator lamp 4 flashes yellow.
%
It can take up to 20 seconds before the indi‐
cator lamp flashes yellow.
#
Release the previously pressed button.
Indicator lamp 4 continues to flash yellow.
#
Point remote control 5 from a distance of
1 cm to 8 cm towards button 1, 2 or 3.
#
Press and hold button 6 of remote control
5 until one of the following signals appears:
R
Indicator lamp 4 lights up green contin‐
uously. Programming is complete.
R
Indicator lamp 4 flashes green. Pro‐
gramming was successful. Additionally,
synchronisation of the rolling code with
the door system must also be carried out.
#
If indicator lamp 4 does not light up or flash
green: repeat the procedure.
#
Release all of the buttons.
%
The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronising the rolling code
Requirements:
R
The door system uses a rolling code.
R
The vehicle must be within range of the
garage door or door drive.
198
Driving and parking