Users Manual Part 3
Table Of Contents
- Climate control
- Overview of climate control systems
- Operating the climate control system
- Switching climate control on/off
- Switching climate control on/off via the rear operating unit
- Calling up the air conditioning menu
- Activating/deactivating the A/C function via the multimedia system
- Setting climate control to automatic mode
- Setting climate control to automatic mode via the rear operating unit
- Overview of the air distribution settings
- Setting the air distribution
- Setting the footwell temperature
- Setting climate control for the rear passenger compartment (multimedia system)
- Activating/deactivating the climate control synchronisation function via the multimedia system
- Demisting the windows
- Switching air-recirculation mode on/off
- Switching residual heat on/off
- Switching residual heat on/off via the rear operating unit
- Activating/deactivating ionisation
- Fragrance system
- Information on the windscreen heater
- Stationary heater/ventilation
- Air vents
- Driving and parking
- Driving
- DYNAMIC SELECT switch
- Automatic transmission
- Function of the 4MATIC
- Refuelling
- Parking
- Driving and driving safety systems
- Driving systems and your responsibility
- Information on vehicle sensors and cameras
- Overview of driving systems and driving safety systems
- Function of ABS
- Function of BAS
- Function of ESP®(Electronic Stability Program)
- Activating/deactivating ESP®(Electronic Stability Program)
- Function of ESP®Crosswind Assist
- Function of ESP®trailer stabilisation
- Function of EBD
- Function of STEER CONTROL
- Function of Active Brake Assist
- Setting Active Brake Assist
- Function of Adaptive Brake Lights
- Cruise control and limiter
- Active Distance Assist DISTRONIC
- Function of Active Speed Limit Assist
- Function of route-based speed adaptation
- Setting route-based speed adaptation
- Active Steering Assist
- Function of Active Lane Change Assist
- Activating/deactivating Active Lane Change Assist
- Function of Active Emergency Stop Assist
- Function of Active Traffic Jam Assist
- Activating/deactivating Active Traffic Jam Assist
- Function of Hill Start Assist
- HOLD function
- AIRMATIC
- E-ACTIVE BODY CONTROL
- Parking Assist PARKTRONIC
- Reversing camera
- 360° Camera
- Active Parking Assist
- ATTENTION ASSIST
- Traffic Sign Assist
- Traffic Light Assistant
- Blind Spot Assist and Active Blind Spot Assist with exit warning
- Active Lane Keeping Assist
- Trailer hitch
- Bicycle rack function
- Vehicle towing instructions
- Instrument Display and on-board computer
ECO start/stop function
Operation of the ECO start/stop function
%
The ECO start/stop function is available only
in the C, A, ; and = drive pro‐
grams (depending on the setting).
The engine is switched off automatically in the
following situations if all vehicle conditions for
an automatic engine stop are met:
R
you brake the vehicle to a standstill in trans‐
mission position h or i.
R
vehicles with a 48 V on-board electrical
system: you depress the brake pedal when
travelling at a low speed.
%
When the HOLD function is active and in
transmission position j, the engine can
stop in spite of an intelligent stop inhibitor,
e.g. when stopping at a stop sign with no
vehicle in front.
The engine is restarted automatically if:
R
you engage transmission position h or k.
R
you depress the accelerator pedal.
R
an automatic engine start is required by the
vehicle.
R
vehicles with a 48 V on-board electrical
system:
-
you release the brake pedal on a downhill
gradient and the vehicle does not roll.
-
the vehicle rolls on a downhill gradient
and does not enter glide mode at
20 km/h.
ECO start/stop function symbols in the driver
display:
R
the symbol è (green) appears when the
vehicle is at a standstill: the engine was
switched off by the ECO start/stop function.
R
the symbol ç (yellow) appears when the
vehicle is at a standstill: not all vehicle condi‐
tions for an engine stop have been met.
R
neither the symbol è nor ç appears
when the vehicle is at a standstill: an intelli‐
gent stop inhibitor was detected, e.g. a stop
sign.
R
the symbol s appears: the ECO start/
stop function is deactivated or there is a mal‐
function.
If the engine was switched off by the ECO start/
stop function and you leave the vehicle, a warn‐
ing tone sounds and the engine is not restarted.
In addition, the following display message
appears in the driver display:
Vehicle is operational Switch off ignition before
exiting
If you do not switch off the ignition, the ignition
is automatically switched off after three
minutes.
Driving and parking
181