Users Manual Part 2
Table Of Contents
- Seats and stowing
- Notes on the correct driver's seat position
- Seats
- Adjusting the front seat electrically
- Adjusting the front passenger seat electrically from the driver's seat
- Adjusting the front passenger seat electrically from the rear
- Adjusting the rear seats electrically
- Setting the fully reclined position
- Head restraints
- Configuring the seat settings
- Setting automatic seat adjustment
- Setting automatic adjustment of the lateral support (active multicontour seat)
- Overview of massage programs
- Selecting the massage programme for the front seats
- Resetting seat settings
- Switching the seat heating on/off
- Setting the panel heating
- Switching the seat ventilation on/off
- Steering wheel
- Easy entry and exit feature
- Operating the memory function
- Memory function in the rear compartment
- Stowage areas
- Notes on loading the vehicle
- Stowage spaces in the vehicle interior
- Overview of the luggage net hooks
- Opening the through-loading feature in the rear compartment
- Locking the through-loading feature in the boot
- Using the bag hooks
- EASY-PACK boot box
- Opening the stowage space under the boot floor
- Attaching a roof luggage rack
- Cup holders
- Ashtray and cigarette lighter
- Sockets
- Coolbox
- Wireless charging of the mobile phone and connection with the exterior aerial
- Fitting and removing the floor mats
- Light and sight
- Exterior lighting
- Notes on adjusting the lights when driving abroad
- Information about lighting systems and your responsibility
- Light switch
- Operating the combination switch for the lights
- Activating/deactivating the hazard warning lights
- Adaptive functions MULTIBEAM LED and DIGITAL LIGHT
- Adaptive Highbeam Assist Plus
- Setting low beam
- Setting the exterior lighting switch-off delay time
- Switching the surround lighting on/off
- Interior lighting
- Windscreen wipers and windscreen washer system
- Exterior lighting
Operating the combination switch for the
lights
1
High beam
2
Turn signal light, right
3
Headlamp flashing
4
Turn signal light, left
#
Use the combination switch to activate the
desired function.
High beam
#
To switch on: turn the light switch to the
L or à position.
#
Push the combination switch in the direction
of arrow 1.
When the high beam is activated, the indica‐
tor lamp for low beam L will be deactiva‐
ted and replaced by the indicator lamp for
high beam K.
#
To switch off: push the combination switch
in the direction of arrow 1 or pull it in the
direction of arrow 3.
Headlamp flashing
#
Pull the combination switch in the direction
of arrow 3.
Turn signal light
#
To indicate briefly: push the combination
switch briefly to the point of resistance in the
direction of arrow 2 or 4.
The corresponding turn signal light will flash
three times.
#
To indicate permanently: push the combi‐
nation switch beyond the point of resistance
in the direction of arrow 2 or 4.
Vehicles with Active Lane Change Assist:
R
Indicator operation activated by the driver
can extend for the duration of the lane
change.
R
If the driver indicated directly beforehand
but a lane change was not immediately
possible, the turn signal indicator may
activate automatically.
Light and sight
145