Users Manual Part 1

Table Of Contents
with the traffic conditions, and contact
a qualified specialist workshop.
Vehicles with a 48 V on-board electrical sys‐
tem (EQ Boost technology)
&
DANGER Risk of fatal injury by touching
damaged high-voltage components
Vehicles with a 48 V on-board electrical sys‐
tem contain individual high-voltage compo‐
nents. These high-voltage components are
under high voltage.
If you modify component parts of these high-
voltage components or touch damaged com‐
ponent parts, you may be electrocuted.
High voltage components may be damaged
in an accident, although the damage may not
be visible.
#
Never perform modifications to compo‐
nent parts of high-voltage components.
#
Never touch damaged component parts
of high-voltage components.
#
Never touch component parts of high-
voltage components after an accident.
Vehicles with a 48 V on-board electrical system
contain high voltage components. These compo‐
nents are marked with a high voltage label:
All work on high voltage components must be
carried out at a qualified specialist workshop.
Declaration of Conformity
Electromagnetic compatibility
The electromagnetic compatibility of the vehicle
components has been checked and certified
according to the currently valid version of Regu‐
lation UN R10.
Wireless vehicle components
For EU and EFTA countries only:
The following information applies to all wireless
components of the vehicle and of the informa‐
tion systems and communication devices inte‐
grated into the vehicle:
The wireless components of this vehicle comply
with the basic requirements and all other rele‐
vant conditions of Directive 2014/53/EU. You
can obtain further information from a Mercedes-
Benz Service Centre.
Below are the addresses of the manufacturers of
wireless components. The addresses cannot be
displayed on the equipment due to its size or
type.
Brazil only:
Note on the two-way radio systems in the vehi‐
cle:
24
General notes