User's Manual
Table Of Contents
- Uconnect™ ACCESS USER'S MANUAL
- Identifying Your Radio
- Safety Guidelines
- Uconnect™ Access Overview
- Uconnect™ 3.0
- Uconnect™ 5.0
- Uconnect™ 8.4A
- Uconnect™ 8.4A System
- Radio Mode
- Media Mode
- Uconnect™ Phone
- Uconnect™ Voice Command
- Navigation
- Navigation Registration (Uconnect™ 8.4A Only)
- Getting Started
- Main Menu
- Where To?
- Where To? – Address
- Where To? – Recent
- Where To? – Point of Interest
- Where To? – Favorite Destinations
- Where To? – Intersection
- Where To? – Go Home
- Where To? – Trips
- Where To? – GEO Coordinate
- Where To? – Point on Map
- Where To? – City Center
- Where To? – Closest City
- Where To? – Phone
- Before Route Guidance
- View Map
- View Map – Settings
- Settings – Map Setup
- Settings – Guidance
- Information
- Information – Where Am I?
- Information – Trip Computer
- Emergency
- Emergency – Hospital
- Emergency – Police
- Emergency – Fire Department
- Security Features
- Remote Service Features
- Uconnect™ 8.4AN
- Uconnect™ 8.4AN System
- Radio Mode
- Media Mode
- Uconnect™ Phone
- Uconnect™ Voice Command
- Navigation
- Getting Started
- Main Menu
- Where To?
- Where To? – Address
- Where To? – Recent
- Where To? – Point of Interest
- Where To? – Favorite Destinations
- Where To? – Intersection
- Where To? – Go Home
- Where To? – Trips
- Where To? – GEO Coordinate
- Where To? – Point on Map
- Where To? – City Center
- Where To? – Closest City
- Where To? – Phone
- Before Route Guidance
- View Map
- View Map – Settings
- Settings – Map Setup
- Settings – Guidance
- Information
- Information – Where Am I?
- Information – Trip Computer
- Emergency
- Emergency – Hospital
- Emergency – Police
- Emergency – Fire Department
- Security Features
- Remote Service Features
Changing the Volume
1. Start a dialogue by pressing the Voice Command
button.
2. Say a command (e.g., “Help”).
3. Use the ON/OFF VOLUME rotary knob to adjust the
volume to a comfortable level while the Voice Com-
mand system is speaking. Please note the volume
setting for Voice Command is different than the audio
system.
Starting Voice Recognition (VR) Session in
Radio/Player Modes
In this mode, you can say the following commands:
NOTE: The commands can be said on any screen when
a call is not active after pushing the Uconnect™ Voice
Command
button.
Disc
To switch to the disc mode, say “Change source to Disc”.
This command can be given in any mode or screen:
• “Track” (#) (to change the track)
1
Uconnect™ ACCESS USER’S MANUAL 209