User's Guide
Table Of Contents
- Explanation of symbols
- Contents
- Description of functions
- Introduction
- Before initial use
- Safety notes
- WARNING
- If the driver is distracted, this can cause accidents and injuries. Operating the radio system, a cellphone or phoning can distract from traffic conditions.
- At operation of a cellphone or radio device without connection to an external antenna, the limiting value for electromagnetic radiation can be exceeded in the vehicle and consequently endanger the health of driver and passengers. This also applies if...
- ● Keep a minimum distance of 20 centimeters between antenna of a cellphone and an active medical implant, e.g., a cardiac pacemaker, because cellphones can negatively influence the function of active medical implants.
- WARNING
- Connection lines of external devices can hinder the driver.
- ● A cellphone must always be switched off in environments with special regulations and if the use of cellphones is prohibited.
- NOTE (continuation)
- NOTE (continuation)
- The radiation emitted from a switched-oncellphone can interfere with sensitive technical and medical devices, which can result in malfunction or damage to the device.
- WARNING
- Overview of control elements
- Basic operating principles
- Audio and media mode
- Radio mode
- Media mode
- Topic introduction
- Requirements of media sources and audio files
- Playback sequence of audio data carriers
- MEDIA main menu
- Switch media source
- Manual song switch
- Folder and song selection from list
- Switch display mode
- Switch playback mode (MIX, REPEAT)
- Insert or eject CD
- Insert or withdraw SD card
- External audio source on multimedia jack AUXIN
- Connect external audio source, data carrier or iPod™ to a USB
- Connect external audio source via Bluetooth®
- Phone control (PHONE)
- Introduction to phone control
- Topic introduction
- Supplementary information and warnings:
- Phoning and operating phone control while driving can distract from traffic conditions and result in accidents.
- ● Select loudspeaker levels so that acoustic signals from outside can be heard well at any time, e. g., the siren of rescue services.
- ● In areas of no or deficient cellphone network supply and possibly in tunnels, garages and undergrounds passageways, a phone call might be interrupted and it might be impossible to reestablish connection – including any emergency calls!
- High speeds, poor weather and road conditions as well as network quality can hinder or interrupt a phone call in a vehicle.
- Supplementary information and warnings:
- General information
- Sites with special regulations
- Couple and connect cellphone with radio
- Topic introduction
- Description of phone control
- Introduction to phone control
- Settings
- Menu and system settings (SETUP)
- Topic introduction
- Supplementary information and warnings:
- Open the Sound settings menu
- Adjust playback volume of external audio sources
- First read and observe the safety notes on page 3 and the introductory information on page 31.
- Display: Meaning
- First read and observe the safety notes on page 3 and the introductory information on page 31.
- Display: Meaning
- First read and observe the safety notes on page 3 and the introductory information on page 31.
- Display: Meaning
- Topic introduction
- Menu and system settings (SETUP)
- Introduction
- Abbreviations used
- Index
7
Adjustment knob: The function depends on the respective operating state.
– In all radio operating types for manual station or channel setting, rotate and press for starting
and stopping the intro check (SCAN).⇒Page 10.
– In media mode for opening the song list, rotate ⇒Page 14.
– To mark menu items in long lists, rotate and press to call the marked item, e. g., station selection
from station list.
– To change your own settings, rotate, e. g., volume adjustment (GALA).
8
USB connection: For connecting external data carriers ⇒Page 14.
9
AUXIN multimedia jack: For connecting external audio sources ⇒Page 14.
10 SD card slot: To insert SD cards ⇒Page 14. Insert SD card with the cut-off corner first and with the
label face up (contact area face down) carefully into the slot.
6 Function description