Motorized Toy Car User Manual

.354"
36
TM
35
.354"
34
T
M
17
M0412a-0920
ASSEMBLY
F
Steering
Stop
Neck of
Vehicle Body
• First, fit the tab on the steering stop into the curved slot in the
lower steering bushing
A
.
• Hold the steering stop in place.
• Then, slide the handlebar assembly on the vehicle frame neck
and over the steering stop
B
.
Handlebar
Assembly
A
B
.354 (Small Diameter)
Cap Nut
Fork Axle
• Place a .354 (small diameter) cap nut on a flat surface, inside
up. Fit the end of the fork axle into the cap nut.
• Tap the opposite end of the fork axle with a hammer to secure
the cap nut on the axle. Pull on the cap nut to be sure it is
securely assembled.
• Slide the fork axle up through the bottom of the front fork,
through the frame neck and steering stop, and out the top of
the front fork.
• Fit a .354 (small diameter) cap nut on the end of the
fork axle.
• Support the fork axle and tap the cap nut with a hammer to
secure it on the end of the fork axle.
Hint: You may need the help of another adult to hold the fork
axle in place while you secure the cap nut.
• Pull on the .354 cap nut to be sure it is secure on the fork axle.
.354 (Small Diameter)
Cap Nut
Fork Axle
Front Fork
Assembly
37
• Insert the handlebar harness into
the wire clip on the side of the
vehicle body.
T
M
Wire
Clip
Handlebar
Harness
Wire
Clip
Handlebar
Harness