Operation Manual

Table 18. Rear (Passenger) Control Audio Functions

FUNCTIONNAMEICONITEM

Cycles to next available audio

source.

Mode1

Tuner: Seek up.

Media: Next file.

Next/Seek

Tuner: Seek down.

Media: Previous file.

/Seek

Down

If Equipped: Press and hold

to transmit on CB/intercom.

CB Push-

to-Talk

Increases volume.Volume Up

Decreases volume.Volume

Down

HEADSET CONNECTORS

Do not select a volume level that blocks out traffic noise

or interrupts the concentration necessary for safe opera-

tion of the motorcycle. Distractions or a volume level that

blocks out traffic noise could cause loss of control res-

ulting in death or serious injury. (00539b)

Do not pull on the cord to remove the headset from the

socket. Pull on the headset jack to disconnect the headset

from the socket. (00174a)

See Figure 8 and Figure 9. Some vehicles have a rider headset

connector on the fuel tank panel and a passenger headset

connector on the left speaker pod. The headsets are used to

operate the CB, intercom, voice recognition commands and

other features on equipped models.

Use the Harley-Davidson 7-pin DIN headset that is supplied

with equipped models or purchased from a Harley-Davidson

dealer. Other headset microphones are not compatible. See

the instructions that are included with the headset to install in

a helmet. Connect the headset by aligning the ridge on the

Controls and Components 23