Operation Manual

VEHICLE STATUS
See Figure 138. Press the VEHICLE INFORMATION switch
to display measurements and status information for the
motorcycle. Press the switch again to exit the Vehicle Status
screen.
NOTE
Holding the VEHICLE INFORMATION switch too long will
activate the high contrast day colors on the screen.
om01787b
1
2
3
4
1. Air temperature
2. Engine oil pressure
3. Engine Idle Temperature Management System
(EITMS)
4. Display more status screens (if equipped with
TPMS)
Figure 138.Vehicle Status Screen
AIR TEMPERATURE
See Figure 138.The current air temperature of the surrounding
environment is measured by a sensor in the fairing. The
measurement can be affected by surrounding conditions at
low speeds, such as idling in heavy traffic. This measured
temperature does not necessarily indicate frost or other road
conditions.
ENGINE OIL PRESSURE
See Figure 138. Engine oil pressure normally varies from 5
psi (34 kPa) at idle speed to 30-38 psi (207-262 kPa) at 2000
rpm when engine is at normal operating temperature of 230
°F (110 °C).
If oil pressure is low, check the oil supply. If the oil pressure
lamp is also on, stop the engine immediately and do not ride
further. Refer to the vehicle owner's manual or see an author-
ized Harley-Davidson dealer for service as necessary.
ENGINE IDLE TEMPERATURE
MANAGEMENT SYSTEM (EITMS)
See Figure 138. The Engine Idle Temperature Management
System (EITMS) provides limited cooling of the rear cylinder
during prolonged idle conditions or traffic congestion. The
EITMS status is displayed as ACTIVE, ENABLED or DIS-
ABLED. See the vehicle owner's manual for more information
about this feature.
193
VEHICLE STATUS