Operation Manual

VOICE RECOGNITION
Voice recognition provides a hands-free alternative to operate
many Boom! Box functions. Commands spoken into a headset
microphone can instruct the system to play a media file, make
a phone call, navigate to a destination, tune to a frequency or
perform other features.Voice commands can be used to access
functions that are otherwise locked out while the motorcycle
is in motion.
To make full use of the system and to reduce distraction while
riding, take time to learn voice commands for features that you
commonly use.
NOTES
• Voice recognition on 4.3 models is only supported for
phone functions.The 4.3 phone commands are available
in English only. Refer to Table 45.
• Some vehicles do not have headset connectors. A P&A
headset connection kit must be installed on the vehicle to
use voice command functions.
ACTIVATING VOICE RECOGNITION
1. Press the VOICE RECOGNITION hand control switch.
The system beeps and prompts for a command. The
system shows a list of commands (teleprompter). The
voice recognition icon appears in the status bar.
2. After the beep, speak a command into the headset
microphone.
3. Respond to the system with additional information if
needed.
a. Prompts: The system prompts if additional informa-
tion is required to complete a command.
b. Multiple options: If multiple options are available for
your command, the system displays a numbered list
of options to choose from. Speak the appropriate line
number, such as LINE TWO.
c. Barging in: To interrupt the prompt, press the VOICE
RECOGNITION switch during the prompt and speak
the desired command after the beep.
NOTE
Voice commands are universal rather than mode-specific. For
example, a media command can be used while in tuner mode.
The system will switch to media mode and carry out the com-
mand.
CANCELLING VOICE RECOGNITION
Hand control: Press and hold the VOICE RECOGNITION
switch.
Voice command: At any time, say CANCEL to terminate the
current session.
183
VOICE RECOGNITION