Operation Manual

SIMULATING A ROUTE
A route simulation can be viewed before committing to the
route. The route simulation can only be used while the motor-
cycle is not moving.
1. When a destination has been selected, select the option
button (before pressing Go).
2. Select Simulate Route.The route simulation will be played
on the map. Audible turn guidance will also be played.
3. To exit route simulation, select the Back button.
4. To commit to the route, select the Back button again.
Select Go.
CALLING A DESTINATION: ROUTE ACTIVE
There are occasions when calling a destination is helpful to
determine operating hours or get information.
1. With a phone connected and the route active on the map,
select the option button.
2. Select Destinations.
3. Select the option button.
4. Select Call. Select OK to confirm.
CALLING A DESTINATION: ROUTE NOT
ACTIVE
1. With a phone connected, select a destination (such as a
POI).
2. After the route is calculated (but before selecting Go),
select the option button.
3. Select Call. Select OK to confirm.
TRIP SUMMARY
A summary of the current route can be displayed at any point
during a ride.The summary shows start and end time, mileage
information and other data.
1. During an active route, select the option button on the
map.
2. See Figure 128. Select Trip Summary.
Navigation 173